l
1000BASE-T
Pin assignment Pin No. Signal name Abbr. Signal direction
1 Communication data DA + BI_DA + I/O
2 Communication data DA - DI_DA - I/O
3 Communication data DB + BI_DB + I/O
4 Communication data DB - BI_DC + I/O
5 Communication data DC + BI_DC - I/O
6 Communication data DC - BI_DB - I/O
7 Communication data DD + BI_DD + I/O
8 Communication data DD - BI_DD - I/O
Wiring
Describes the connection processing to connector hood of shield as the following. The connection
processing is changed according to the transfer speed.
•
10 BASE-T/100 BASE-TX
Connect both ends of the cable shield to the connector hood. Or, connect only the shield of one end
of the cable, switching hub side, to the connector hood.
• 1000 BASE-T
Connect both ends of the cable shield to the connector hood.
6 I/O Interface
6-38
FH Series Vision System Hardware Setup Manual (Z366-E1)
To Next Page
Loading...
