25
When necessary
14. Maintenance and Storage
Arranging the Panel Unit
The cord can rewind automatically.
Pull the panel unit upwards to extend the cord attaching
the display to the main unit. The cord is automatically
rewound when you store the panel in the main unit.
1
Pick up the panel unit and
rewind the cord into the unit
■ If the cord does not rewind automatically...
Untwist the cord, extend it once and try again.
Do not extend the cord from the unit beyond
the red marker line. Otherwise, it may cause fault.
2
Push the panel unit into the holder
Storage
•
Do not store the unit in the following conditions:
- Humidity, where moisture or water may get into the unit
- High temperatures, direct sunlight or dusty places
- Places with the risk of sudden shocks or vibrations
- In places where chemicals are stored or where corrosive gas is present.
Maintenance
•
Always keep the unit clean before use.
•
Wipe the unit with a soft dry cloth.
•
If the unit is seriously dirty or shared with others with an infectious disease, such as a skin disease,
use a cloth moistened with water or neutral detergent and squeeze it well before wiping the unit,
then wipe off with a dry cloth.
Otherwise it may cause skin disease infection.
•
Do not use gas oil, or other thinner solvents to clean the unit.
You can use cleaning alcohol to clean the electrodes, but do not use it on other parts of the unit.
•
Do not wash the unit and the panel with water.
•
Do not carry out repairs of any kind by yourself. This product is calibrated at the time of
manufacture. If at any time you question the accuracy of measurements, please contact your
authorized OMRON distributor.
Click
To Next Page
Loading...
