Omron HBP-1120 - Advanced Measurement Features; Pulse;Movement Detection and Auscultation Mode

19
EN
Caution
• The accuracy of a flashing measurement value that is outside the
measurement range is not guaranteed. Always check the patient’s
condition before deciding what steps to take.
NOTE:
• If inflation is insufficient, inflation may restart automatically while
measurement is in progress.
,UUHJXODUSXOVHZDYHGHWHFWLRQIXQFWLRQ
If the pulse wave interval becomes irregular during measurement, the
irregular pulse wave detection icon will light up.
%RG\PRYHPHQWGHWHFWLRQIXQFWLRQ
If body movement is detected during measurement, deflation stops for
5 seconds and alternately below the value.
After 5 seconds, measurement resumes, and an attempt is made to
complete measurement in one cycle.
NOTE:
• When the body movement detection function has been activated, the
irregular pulse wave icon appears in the measurement result.
Measurement in “Auscultation Mode”
,Q³$XVFXOWDWLRQ0RGH´WKLVGHYLFHGRHVQRWPHDVXUHEORRG
pressure. Measurement should be performed by a health care
professional using a stethoscope.
The healthcare professional uses a stethoscope to determine SYS
and DIA by means of the auscultation method.
1. Make sure the power is on.
“0” is displayed.
2. Press the [Auscultation] button.
The auscultation icon appears and the
device enters “Auscultation Mode”.