26
2. Remain still and do not talk until the entire measurement
process is complete.
The “ ” symbol flashes at every heartbeat.
After your monitor has detected your blood pressure and pulse rate,
the cuff automatically deflates. Your blood pressure and pulse rate are
displayed.
If either the systolic or the diastolic reading is high (refer to sub-
section 1.3), the “ ” symbol appears.
3. Press the [START/STOP] button to turn your monitor off.
•Your monitor automatically turns off after 2 minutes.
•Wait 2 - 3 minutes between measurements. The wait time allows the
arteries to decompress and return to their pre-measurement state.
You may need to increase the wait time depending on your
individual physiological characteristics.
INFLATINGSTART COMPLETED
To Next Page
Loading...
