8. Other Settings of the Monitor
EN42
8.2
Restoring Your Monitor to the Default Settings
To delete all the information stored in your monitor, follow the instructions below. Make sure that your monitor is turned off.
1. While holding the button down, press and hold the BP
[START/STOP] button for more than 10 seconds.
2. Release the button and BP [START/STOP] button when
“CLr” appears on the BP reading display.
Your monitor reverts back to the default settings.
3. Press the BP [START/STOP] button to turn your monitor off.
Note
• Reverting to the default settings of your monitor does not delete the information in the app.
• Your monitor will automatically turn off after 2 minutes.
• You will need to re-pair your monitor when using the monitor again. Without re-pairing, your blood pressure readings will not be
transferred to your app.
To Next Page
Loading...
