Omron IntelliSense HEM-650 - Error Indicators

19
ERROR INDICATORS
SYMBOL CAUSE CORRECTION
After several seconds
Movement during
measurement.
Press the START/STOP
button to turn the unit off.
Remove the monitor from
your wrist. Refer to
“Taking a Measurement”
on page 14.
Wait 2-3 minutes.
Take another measurement.
The cuff is not
fastened securely.
Remove the monitor from
your wrist. Refer to
“Applying the Wrist Cuff”
on page 13.
Wait 2-3 minutes.
Take another measurement.
Wrist is not in the
correct position.
Refer to “Taking a
Measurement” on page 14.
Make sure the wrist
measurement selection is
correct. Refer to page 10.
Batteries are worn.
Replace the two “AAA”
batteries. Refer to
“Battery Installation”
on page 8.
After several seconds
Cuff
over-inflated.
Repair service required.
Refer to the warranty
information on page 22.
HEM-650-IM-US-8012 12/7/05 10:22 AM Page 19