9
ADVANCED POSITIONING SENSOR
The Advanced Positioning Sensor, A.P.S.
®
will assure you that the
unit is in the correct position before it starts to take a measurement.
1. Press the SET button
while the power is turned
off. The Position Sensor
symbol ( ) will
appear on the display.
2. Press the MEM button to select “on” or “oFF”. Press the
START/STOP button to save this selection. When the feature
is “on” the symbols will appear on the display. The heart symbol
will begin to flash when your wrist is in the correct position.
POSITION SENSOR ALARM
The Sensor Alarm emits sound to help you place your wrist in the
correct position.
1. Press the SET button twice
while the power is turned off.
The Position Sensor Alarm
symbol ( ) will appears on
the display.
The alarm set “on 1” emits a series of blips if your wrist is too
far away from the correct measuring position and beeps slowly
once your wrist is in the correct position. When “on 2” is set the
alarm only beeps once your wrist is in the correct position.
2. Press the MEM button to select “on 1”, “on 2” or “oFF”.
Press the START/STOP button to save this selection.
HEM-650-IM-US-8012 12/7/05 10:22 AM Page 9
To Next Page
Loading...
Need help?
General
