21
3.Using the Unit
EN
3.5
Using the Memory Function
The unit automatically stores up to 14 sets of measurement values
(blood pressure and pulse rate). When 14 sets of measurement values
are stored, the oldest record is deleted to save the most recent values.
1. Press the M button.
Note: If there are no measurements results
stored in memory, the screen to the right is
displayed.
Important: If your systolic or diastolic
pressure is outside the
standard range, the
heartbeat symbol will blink
when the measurement
result is displayed. Refer
to 3.3, number 4.
2. Press the M button repeatedly
to cycle through the previous
measurement results.
Keep the button pressed
down to cycle rapidly through
the previous results.
If the irregular heartbeat
symbol was displayed at the time of a measurement, this is
displayed when that result is displayed.
HEM-7102-IM_main.book Page 21 Friday, October 5, 2007 1:41 PM
To Next Page
Loading...
Need help?
General
