Omron NJ501 - 7 Connection Procedure; Overview of Setting up Remote I;O Communications

7．Connection Procedure
7. Connection Procedure
This section describes how to connect the Controller to the Safety Network Controller on
DeviceNet.
This document explains the procedures for setting up the Controller and the Safety Network
Controller from the factory default setting. For the initialization, refer to Section 8 Initialization
Method.
9
Personal computer
Safety
Network
Controller
Controller
7.1. Overview of Setting Up Remote I/O Communications
The following shows the relationship of processes to operate remote I/O communications.
S Settings made with Network
Configurator
•Creating network configuration
•Setting device (creating scan list)
ettings made with Sysmac Studio
•Setting parameters
(DeviceNet Unit)
•Setting global variables
(names and AT, etc)
•Building
•Settings in the Watch Tab Page
Network Configurator
Sysmac Studio
Transferring
scan list
Transferring
parameters
Transferring
project data