Omron NJ501 - Setting up the Safety Network Controller

7．Connection Procedure
7.4. Setting Up the Safety Network Controller
Set up the Safety Network Controller.
7.4.1. Hardware Setting
Set the hardware switches on the Safety Network Controller.
Precautions for Correct Use
Make sure that the power supply is OFF when you perform the setting up.
1
Check the hardware switches on
the Safety Network Controller by
referring to the figure on the
right.
2
Set the Node Address Switches
X10 and X1 to 0.
*Set the node address to 0.
3
Set pin 1 of the DIP switch to
OFF and pin 2 of the DIP switch
to ON.
*Set the baud rate to 500 kbps.
21