7．Connection Procedure
5
Set pin 2 of the DIP switch to
ON. (Set pins 1, 3 and 4 of the
DIP switch to OFF.)
*Set the baud rate to 500 kbps.
All pins are set to OFF at the factory.
6
Connect the DeviceNet Unit to
the Controller.
Connect the personal computer,
Safety Network Controller and
Controller using the DeviceNet
cable and USB cable as shown
in 5.2 Device Configuration.
Turn ON the power supply to
the
Controller and DeviceNet.
DeviceNet
CJ1W-DRM21
cable
USB cable
NJ501-1500
End Cover
Power Supply Unit
Additional Information
DeviceNet cables, please cut to the length you want to use.
For details on communications specifications and wiring, refer to in the
DeviceNet OPERATION MANUAL (Cat. No. W267).
2-4 Wiring Methods
12
To Next Page
Loading...
