7．Connection Procedure
6
The Communications Setup
Dialog Box is displayed.
Select the Direct connection via
USB Option for Connection
Type.
Click the OK Button.
7
Select Online from the
Controller Menu.
A confirmation dialog is
displayed. Click the Yes Button.
*A displayed dialog depends on
the status of the Controller
used. Click the Yes Button to
proceed with the processing.
8
When an online connection is
established, a yellow bar is
displayed on the top of the Edit
Pane.
Additional Information
For details on the online connections to a Controller, refer to Section 5 Going Online with a
Controller in the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).
9
Select Synchronization from
the Controller Menu.
17
To Next Page
Loading...
