7．Connection Procedure
9
A password entry dialog box is
displayed. If you do not need a
password, click the OK Button.
* For details on a password,
refer to 3-7 Device Password
Protection in the CIP Safety
TM
on DeviceNet System
Configuration Manual (Cat. No.
Z905).
10
A confirmation dialog box is
displayed. Click the Yes Button.
*If a message is displayed
stating the TUNID is invalid,
refer to Section 8.2 and perform
the initialization operation.
11
If a dialog box is displayed in
step 8, the confirmation dialog
box shown on the right is
displayed.
Click the No Button to remain in
PROGRAM mode.
37
12
On a confirmation dialog box,
click the OK Button.
13
After transfer, the Safety
e idle Network Controller is in th
mode, so the MS LED indicator
flashes green.
To Next Page
Loading...
