9
03 Installation
03.2 Installation/removal method of the terminal block cover
Disassemble the terminal block cover in the following steps:
1. Loosen the screw(s) securing the terminal block cover.
2. Press the terminal block cover in the direction of the arrow and lift it down to remove it.
03.3 Wiring of the 3G3MX2
Power connections
Initially, it must be determined whether the frequency inverter used requires a three-phase power supply only
with terminals [R/L1], [S/L2] and [T/L3] or a single-phase power supply only with terminals [L1] and [N]. The
corresponding connections can be seen in the figure below.
WARNING: Do not connect AC voltage to output terminals
It must be ensured that no AC voltage is connected to the output terminals. Otherwise, the
inverter may be damaged and there is a risk of injury and/or fire.
To Next Page
Loading...
