Omron SPINOGY 3G3MX2 - Restoring Factory Settings

23
06 Troubleshooting
05.2 Restoring factory settings
The MX2 frequency inverter can be reset to the original factory/default settings. To initialize the inverter, follow
the steps below.
01. Select initialization mode in b084.
02. If b084 = 02, 03 or 04, select initialization target data in b094.
03. If b084 = 02, 03 or 04, select country code in b085.
04. Set 01 in b180.
05. After successful initialization, the display jumps to d001.
Func. code
Name
Description
b084
Initialization
selection
Select initialized data, five option codes:
• 00 no (Clears the trip monitor)
• 01 Trip data (Initializes data)
• 02 Parameters (Clears the trip monitor and
initializes data)
• 03 Trip+Param (Clears the trip monitor and
parameters)
• 04 Trp+Prm+EzSQ (Clears the trip monitor,
parameters and Drive program)
b094
Initialization target
data
Select initialized parameters, four option codes:
• 00 All
• 01 All parameters with the exception of input/
output terminals and communication
• 02 Only parameters registered in U***
• 03 All parameters except those registered in
U*** and b037
b085
Initialization
parameter selection
Select initial data for initialization:
• 00 JPN
• 01 EUR
b180
Initialize trigger
This is to perform initialization by parameter input
with b084, b085 and b094.
Two option codes:
00 No action
01 Initialize