SRTj-R
SRTj-R
38
Nomenclature
SRT2-ROC16
SRT2-ROF16
SRT1-ROC08
SRT1-ROF08
Mounting
Holes
Output Terminals
I/O Power Supply Terminals
Connect 24-VDC power supply
Communications Power Supply Terminals
Connect 24-VDC power supply.
CompoBus/S Terminals
Connect the CompoBus/S communications cable.
Mounting
Holes
DIP Switch
Used for node number setting and holding or
clearing outputs for communications error
.
Note: Always
turn of
f the Unit before changing DIP switch settings.
Mounting
Holes
Output Terminals
I/O Power Supply Terminals
Connect 24-VDC power supply
Communications Power Supply Terminals
Connect 24-VDC power supply.
CompoBus/S Terminals
Connect the CompoBus/S communications cable.
Mounting
Holes
DIP Switch
Used for node number setting and holding or clearing outputs for communications error.
0
to 15
ERR
COMM
PWR
Output HOLD/CLEAR setting (Output model only)
Baud rate setting
Node address setting
Indicators
Indicator Display Color Meaning
PWR Lit Green The communications power supply is ON.
Not lit The communications power supply is OFF.
COMM Lit Yellow Normal communications
Not lit A communications error has occurred or
the Unit is in standby status.
ERR Lit Red A communications error has occurred.
Not lit Normal communications or the Unit is in
standby status.
0 to 15
(see
note)
Lit Yellow The corresponding I/O signal is ON.
Not lit The corresponding I/O signal is OFF.
Note: The
SR
T1-ROj
08 does not have indicators 8 to 15.
To Next Page
Loading...
