SRTj-R
SRTj-R
39
Output HOLD/CLEAR Mode
Mode Pin
1
Setting
HOLD ON
Output status is maintained when a communications error occurs.
CLEAR OFF
Output status is cleared when a communications error occurs.
Note: 1. Pin 1 is factory-set to OFF.
2.
This function is available to the Output T
erminal only
.
Node Number Settings
Node
number
Pin 3 Pin 4 Pin 5 Pin 6
8 4 2 1
0 OFF OFF OFF OFF
1 OFF OFF OFF ON
2 OFF OFF ON OFF
3 OFF OFF ON ON
4 OFF ON OFF OFF
5 OFF ON OFF ON
6 OFF ON ON OFF
7 OFF ON ON ON
8 ON OFF OFF OFF
9 ON OFF OFF ON
10 ON OFF ON OFF
11 ON OFF ON ON
12 ON ON OFF OFF
13 ON ON OFF ON
14 ON ON ON OFF
15 ON ON ON ON
Note: 1.
The node number is factory-set to 0.
2.
For node number setting, refer to the
CompoBus/S Operation Manual (W266).
To Next Page
Loading...
