SRT1-jD08S
SRT1-jD08S
57
Terminal Arrangement and I/O Device Connection Example
Input
SRT1-ID08S
I/O
SRT1-ND08S
Photoelectric Sensor
Proximity Sensor
(Sensor with Teaching Function, Sensor with External Diagnostic
function, Sensor with Bank-switching Function)
24 VDC
Communications
power supply
CompoBus/S
communica-
tions
CompoBus/S
communica-
tions
Communications
power supply
Blue
Brown
Blue
Black
Brown
Photoelectric Sensor
Proximity Sensor
(3-wired Sensor)
Proximity Sensor
(2-wired Sensor)
CompoBus/S
communica-
tions
Communications
power supply
CompoBus/S
communica-
tions
Communications
power supply
Brown
Brown
Blue
24 VDC
Orange
CompoBus/S
CompoBus/S
Output
SRT1-OD08S
CompoBus/S
SOURCE
24 VDC
BDL BDH
–
+
CompoBus/S
communica-
tions
Communications
power supply
Output connector
Pin number
Solenoid, etc.
Valve, etc.
Precautions
Refer to the
CompoBus/S Operation Manual (W266)
before
using
the Unit.
General Safety Precautions
Installation Environment
Do
not install the Unit in the following places.
•
Places with water
, oil, or chemical sprayed on the Unit.
•
Places with rapid temperature changes.
•
Places with high humidity resulting in condensation.
•
Places with intense electric and magnetic fields.
• Places with excessive vibration or shock.
Wiring
To
prevent inductive noise, do not wire power
lines or high-tension
lines
along with or near the cables.
Make sure that the polarity of each terminal is correct.
Make sure that the communications path and power line are con-
nected correctly.
Secure
the cables
properly
. Do not pull the cables with strong force,
otherwise the cables may be disconnected from the terminals or
connectors
of the Unit.
Do
not touch the Unit when the Unit is used in places with high ambi
-
ent
temperatures because the surface temperature of the Unit may
be
high.
Do
not use paint thinner to
clean the surface of the Unit, otherwise
the
surface will be damaged or discolored.
To Next Page
Loading...
