SRT1-jD08S
SRT1-jD08S
58
Correct Use
Use
the Unit under its rated conditions.
Mount the Unit with M4 screws or to DIN tracks securely.
Typical Causes of Communications Errors
• The
cables are not connected correctly
.
•
The node number setting is incorrect.
•
The baud rate setting is incorrect.
• There
is a strong noise source, such as an inverter motor
,
near
the
Unit. Install the Unit as far as possible from the noise source
or
shield the noise source.
Others
Use OMRON’s XS8A-0441 or XS8A-0442 Connectors with the
Unit.
Insert each connector into the Unit until the connector snaps in
place.
Make sure that terminal number 1 of the connector is on the
lock
lever side when inserting the connector
.
Refer
to the
CompoBus/S Operation Manual (W266)
for wiring the
Unit.
To Next Page
Loading...
