SRT1-jjD04S
SRT1-jjD04S
68
Precautions
Refer to the
CompoBus/S Operation Manual (W266)
before
using
the T
erminal.
Refer to page
80 for precautions common to all SR
T1 T
erminals.
General Safety Precautions
Connector Units
Use
only the Connector Units listed in this data sheet for the Sensor
Amplifier Units.
E39-JID01 Terminal Block Unit
Do
not apply any voltage to the T
erminal Block Unit.
Correct Use
Expanding Sensor Amplifier Terminals
1. Remove
the cover from the side of the SR
T1-TjD04S.
(See
Figure
1.)
2. When the cover is removed, you can see the expansion
connector
inside.
3. Connect this expansion connector to the connector located
on
the side of the SR
T1-Xj
D04S. (See Figure 2.)
Figure 1
Cover
Figure 2
Connector
Attaching and Removing Connector Units
(SRT1-TID04S, SRT1-XID04S, E3X-NTj
6, E39-JID01)
Attaching Connector Units
1. Hook Section A of the Connector Unit onto Section B of the
Sensor
Amplifier T
erminal.
2. Push in the Connector Unit until Section C locks inside
Section
D of the Sensor Amplifier T
erminal.
Section C
Section D
Section A
Section B
Bottom View
Section A
Removing Connector Units
1. While
pushing Section D, pull the Connector Unit in direction
E.
2. When Section D releases from the lock, the Connector Unit
can
be removed.
Push here
Section D
To Next Page
Loading...
