5．Applicable Devices and Device Configuration
5.2. Device Configuration
The hardware components to replicate the connection procedures in this guide are as follows:
NX-series CPU Unit
(built-in EtherNet/IP port)
－
－
－
(STP (shielded, twisted-pair) cable of
Ethernet category 5 or higher)
－
HMS
Anybus X-gateway EtherCAT Slave -
EtherNet/IP Adapter
AB7682
HMS EDS file 005A000C004B0300.eds
HMS HMS IPconfig
－
Ver.4.2.0.0
HMS
Anybus Configuration Manager - X-
gateway
－
Ver.1.5.1.1
HMS
USB cable
(USB 2.0-compliant, B connector)
(supplied with X-gateway)
－
Power supply (24 VDC for Controller)
－
－
Power supply
(24 VDC for switching hub)
－
－
Power supply (24 VDC for X-gateway)
－
Precautions for Correct Use
Contact HMS INDUSTRIAL NETWORKS AB to obtain the EDS file specified above before
proceeding.
Precautions for Correct Use
Update Sysmac Studio to the version 1.43 or to a higher version. If you use a version higher
than the one specified, the procedures and related screenshots described in Section 7 and
the subsequent sections may not be applicable. In that case, use the equivalent procedures
described in this guide by referring to the Sysmac Studio Version 1 Operation Manual (Cat.
No. W504).
Power supply
NX102-1200
(built-in EtherNet/IP port 1)
HMS IPconfig and
Anybus Configuration
Manager - X-gateway
installed,
OS: Windows 10)
To Next Page
Loading...
Need help?
General
