53
Appendix A - Programming Menus & Commands
V520-LHA7127
25.Scanner Timeout (Trigger Enabled Mode only)
These commands, which are only applicable in the Trigger enabled mode, establish the time-out period after
the trigger pulse is received. The time-out period is the same whether the scanner is operating in Single,
Multiple or Continuous Read mode.
Computer Command Function/Description Bar Code Command
(Z7)
START/END
Programming Menu
-[8-
Y0
Trigger remains ON
as long as trigger is pulled
(hardware trigger only)
-Z1-
Y1
1 Second after triggering
-Z2-
Y2
2 Seconds after triggering
-Z3-
Y3
3 Seconds after triggering
-Z!-
Y4
4 Seconds after triggering
-Z5-
Y5
6 Seconds after triggering
-Z6-
Y6
8 Seconds after triggering
-Z7-
Y7
10 Seconds after triggering
-Z8-
To Next Page
Loading...
Need help?
General
