55
Appendix A - Programming Menus & Commands
V520-LHA7127
27.Transmitting Error Indications (Trigger Enabled only)
28.Print Quality Adjustments
Computer Command Function/Description Bar Code Command
(Z7)
START/END
Programming Menu
-[8-
5E
Do not transmit error code
-6F-
5F
Transmit “BR” <CR> for bad read
or no read
-6G-
5G
Transmit <STX>“>”<ETX>
for bad read;
<STX>“?”<ETX> for no read
-6H-
5H
Transmit “>”<CR> for bad read
Transmit “?”<CR> for no read
-6I-
5I
Transmit “CAN”<CR> for bad
read or no read
-6J-
5J
Transmit <STX>“CAN”<ETX>
for bad read or no read
-6K-
Computer Command Function/Description Bar Code Command
(Z7)
START/END
Programming Menu
-[8-
X4
For lower density, poor print
quality bar code, e.g., dot matrix
with voids (low analog gain)
-Y5-
X5
For high density, good print
quality bar code without voids
(high analog gain)
-Y6-
X6
Output data obtained from Low
or High analog gain
-Y7-
X7
Output data obtained from Low
and
High analog gain
-Y8-
To Next Page
Loading...
Need help?
General
