3-3
Setting Window
The network settings (IP address and subnet mask) of the Amplifier Unit and the password can be set
in the Setting Window. The values that are set are enabled when the Amplifier Unit is restarted.
(1)
(2)
The result of saving settings is displayed.
(1) Network Settings
Item Description Comments
IP Address The IP address of the amplifier unit can be specified.
Subnet Mask The Subnet Mask of the amplifier unit can be specified.
(2) Password
Item Description Comments
New Password You can set a new password.
If the Save Button is clicked when the password box is empty, the
password
will be cleared. In this state, theV640 Utility Tool V640
Utility Tool and browser interface can be used without entering the
password.
The following characters
can be used for the pass-
word: 0 to 9, a to z, and A
to Z.
Precautions for Correct Use
Never turn OFF the power supply to the Amplifier Unit before a response is received after click-
ing the Save Button. Doing so may damage the Amplifier Unit.
3 V640 Utility Tool Features
3-5
V640 SERIES CIDRW SYSTEM OPERATION MANUAL V640 Utility Tool (Z469-E1)
3-3 Setting Window
3
To Next Page
Loading...
Need help?
General
