Omron YSC-8361 - HOW TO ADJUST THE ZERO POSITION; ERROE MESSAGES & POSSIBLE TROUBLESHOOTING

13
O17
Resume the default
value of all parameters
0～1
O31
0～1
Safety switch function
1 = enable
0 = disable
O32
0～1
Signal polarity of safety
switch
0: Normal closed
1: Normal opened
O35
0～359
Angle of pull back
function
O51
Restore Factory
Defaults
0～1
O69
0～1
Correction mode
1 = Correction when
machine is stopped.
0 = Can not Correct after
trimming
O72
0～10
torque enhancement
function when running at
low speed
0 = Off
1～10 = level 1-10
O84
0～720
Step width for electronic
hand wheel
O85
0～200
Speed for electronic hand
wheel
O86
0～2
Speed Limit Device to
stroke
0：none
1：Digital
2：Analog
8. HOW TO ADJUST THE ZERO POSITION
Press hold and power on to adjust ZERO position for the machine.
Rotate the motor to ZERO position, displays will show the angle.
Press to confirm and save.
9. ERROE MESSAGES & POSSIBLE TROUBLESHOOTING