Omron YSC-8361 - Controller Check

14
ERROE
CODE
DESCRIPTION
SOLUTION
PEDAL
Pedal warning
- Check or replace the pedal
- Pedal not connected
- Do not pedal yet
CARE
Safe Switch problem
- Check the Safe Switch
- Replace the safe switch
KEY1
Machine button
warning
- Do not press machine button
- Replace the buttons
E101
High AC voltage fault
- Check mains voltage
- Stabilize mains voltage
- Use generator
E103
High Bus voltage fault
- Check mains voltage
- Stabilize mains voltage
- Use generator
E106
Bus current overload
- Check the encoder and motor
- Replace the encoder
- Replace the motor
E107
Motor blocked
- Eliminate stiff movement in the machine
- Replace the encoder
- Replace the motor
E110
Encoder/Synchronizer
fault
- check or replace the synchronizer for a
belt-drive machine
- check or replace the encoder for a
direct-drive machine
E190，E290
Software Update
Error
- Software update
- Replace the control
E191,
E291
Software Update
Error
- Software update
- Replace the control
E193,
E293
Software Update
Error
- Software update
- Replace the control
E294
Software Update
Communication Error
- Software update
- Replace the control
E199
Software Update
Error
- Software update
- Replace the control
E900
Communication
problem
- Restart the control
- Replace the control
1. Controller Check
Press hold during power on, it will display “TEST” and then enter the Check
interface. Diplay A display check index, the else display contents.
1.1 Pedal
1.2 Synchronizer