Omron YSC-8361 - OPERATING ELEMENTS; Single start tacking setting; Double start tacking setting

4
start normal sewing. Once the pedal returned to
balance, machine will stop immediately.
▲ As the pedal stepped backward, the end
tacking, trimming and wiping(if selected) will be
done automatically
Constant-Stitch
Sewing
▲ Once the pedal is stepped forward, F, G stitches will
be completed with E times.
▲ Constant-Stitch Sewing will perform the number of
segments and times as setting, when the stitches are
zero, machine will stop immediately.
Bar-Tacking
Sewing
▲ Once the pedal is stepped forward, all the seams of
bar tacking, A, B, C, D sections will be completed with
E times, and the trimming will be done automatically.
▲ The pedal must be returned to balance for next
sewing.
Lower thread
Counter
Enter lower thread counter interface
Soft start
Enable or disable the soft start
Needle Up / Needle
Down
Select the stop position of needle bar
Trimming Enable
Enable or disable the trimming
Interface
Selection
Switch current interface to another
One-Key Default
/Lock keys
Parameter
Function
Enter or exit parameter function interface
Save
Confirm and save current value of parameter
Add
Value increase
Sub
Value decrease
5. OPERATING ELEMENTS
5.1 Single start tacking setting
 A Stitches = 0
Seven-segment display A display 『-』.
Sewing process: B stitches back – normal sewing.
 A Stitches ≠ 0
Sewing process: A stitches forth – B stitches back – normal sewing
5.2 Double start tacking setting