Omron YSC-8361 - OPERATING ELEMENTS; Single end tacking setting; Double end tacking setting; Lower thread counter

5
 A Stitches = 0
Sewing process：B stitches back – B stitches forth – B stitches back –
normal sewing.
 A Stitches ≠ 0
Sewing process：A stitches forth – B stitches back – A stitches forth – B
stitches back – normal sewing
5.3 Single end tacking setting
 A Stitches = 0
Seven-segment display D display 『-』.
Sewing process：C stitches back – end.
 A Stitches ≠ 0
Sewing process：C stitches back – D stitches forth – end.
5.4 Double end tacking setting
 A Stitches = 0
Sewing process：C stitches back – C stitches forth – C stitches back – end.
 A Stitches ≠ 0
Sewing process：C stitches back – D stitches forth – C stitches back – D
stitches forth – end.
5.5 Lower thread counter
Set A11 to “1” to active the counter.
 Enter interface: Press Or Special function interface SN F6(refer to
6.6).
 Initial counter: Press , the initial value of the lower thread counter
which was set previously will be shown. Adjust it to a suitable value.
 How the counter works：
 Display initial value
 The counter reduces by 1 for every 10 stitches sewn.
 If the counter less than 1, the display area will warn and buzzer sounds
for 3 times. After thread trimming, will not start up again. Press
the warning will disappear and sewing will be possible, the counter
reduces continue.
 Press again, the display will return to the initial value
5.6 Production counter
Set A11 to “1” to active the counter.
 Enter interface：Special function interface SN F2,refer to 6.2
 Data acquisition：In SN F2 interface, press will be into collect
process interface, seven-segment display D displays 『L』, seven-segment
displays E,F,G will display the number of stitches for this process. It records
the number of stitches and the number of trimmer. Press to save