Omron ZEN - Page 30

7 Programming Functions ZEN Programmable Logic Module
OMRON ELECTRONICS, S.A. Page 30
7.5.2. Settings in the Parameter Settings Screen
No. of analog comparator A0 to A3
1 I4: Analog input 1
I5: Analog input 2
Comparison data
2 I5: Analog input 2
Constant: 00.0 to 10.5
* Comparison possible
between I4 and I5, I4 and
constant and I5 and
constant
Operator
≥: The corresponding bit switches to ON mode when
comparative data 1 ≥ comparative data 2
≤: The corresponding bit switches to ON mode when
comparative data 1 ≤ comparative data 2
A Parameters can be modified and monitoredMonitoring
enabled/disabled
D Parameters cannot be modified or monitored
7.5.3. Parameter Monitoring in ‘Screen Display’
• Analog input comparisons (When I4 ≤
I5)
Analog comparator
address
Comparison data 1
Operator
Comparison data 2
Monitoring
enabled/disabled
Analog comparator
address
Comparison data 1
Operator
Comparison data 2
Monitoring
enabled/disabled
• Analog input 14 and constant
comparisons (When I4 ≥ constant)
• Analog inputs comparison (When
I4 ≤ I5)
Analog input 1 (I4) present value
Corresponding
bit status
(m:OFF / l:ON)
Analog input 1 (I4) present value
Corresponding
bit status
(m:OFF / l:ON)
Analog input 2 (I5) present value
• Analog comparison and constant
inputs (When I4 ≥ constant)