Omron ZEN - Page 34

7 Programming Functions ZEN Programmable Logic Module
OMRON ELECTRONICS, S.A. Page 34
7.7.2. Settings in the Parameter Settings Screen
L0 No backlight. No switching to show Display function (see note 1)
L1 Backlight. No switching to show Display function (see note 1)
L2 No backlight. Switching to show Display function (see note 2)
Backlight/display
function selection
L3 Backlight. Switching to show Display function (see note 2))
Display start position X (digit): 00 to 11
Y (digit): 0 to 3
CHR Characters (12 max.: Alphanumeric and symbols)
DAT Month/Day (5 digits: @@ / @@)
CLK Hours/Minutes (5 digits: @@ / @@)
I4 to I5 Analog conversion (4 digits: @@ . @)
T0 to T7 Timer present value (5 digits: @@ . @@)
#0 to #3 Holding timer present value (5 digits: @@ . @@)
Display object
C0 to C7 Counter present value (4 digits: @@ @@)
A The parameters can be modified and monitoredMonitoring
enabled/disabled
D The parameters cannot be modified nor monitored
Note.
1. When either L0 or L1 are selected to disable the display function, this
funcion will not automatically be displayed on screen. Use the operating
keys to see the display screen.
2. When either L2 or L3 are selected (toggle to show the display function),
ZEN is able to show the display screen if this function has been enabled. If
everything is correct, the required data will be displayed.
X0 to X11
Y0
to
Y3
Display No.
Display selector
Monitoring enabled/disabled
Display start position
Display object
Display the character string (set when the character
string is selected as the display object)
Character string cursor position
Character selection for alphanumeric strings