Omron ZEN - Page 41

9 Accessories ZEN Programmable Logic Module
OMRON ELECTRONICS, S.A. Page 41
Node number setting
When ZEN has to be connected to the Software, the node number displayed
both in the Software and the CPU must be identical. Follow the steps below to
set the ZEN node number.
Enter the OTHER option and select
NODE No.
Press the OK key to display the Menu.
By pressing the OK key again, the
node number setting is enabled.
The node number is selected by using
the Up/Down and Left/Right keys.
Press the OK key to confirm.
Press the OK key again to complete the
setting.