To Next Page
M
mariewilkersonSep 12, 2025
What to do if the set numeric value is too small on Omron ZX-LDA11 Accessories?
- PpwrightSep 12, 2025
If the set numeric value is too small, input an appropriate numeric value.
What to do if the set numeric value is too small on Omron ZX-LDA11 Accessories?
If the set numeric value is too small, input an appropriate numeric value.
What to do if one-sensor operation was attempted while selecting the A ? B or A + B operation on Omron ZX-LDA11 Accessories?
If one-sensor operation was attempted while selecting the A ? B or A + B operation, perform one-sensor operation by reconnecting the Units and turning OFF two-sensor operation. If that's not possible, initialize the settings.
What to do if attempted two-sensor operation for two Amplifier Units with Intensity Mode ON on one Unit and OFF on the other for Omron Accessories?
If you've attempted two-sensor operation for two Amplifier Units with Intensity Mode ON on one Unit and OFF on the other, use the same Intensity Mode setting for both Amplifier Units.
General| Brand | Omron |
|---|---|
| Model | ZX-LDA11 |
| Category | Accessories |
| Language | English |
Summary of manufacturer's requirements for laser product safety standards.
Precautions for the safe operation and use of laser products.
Details scaling, hold functions, timers, and two-sensor operations for reflective sensors.
Details auto-scaling, hysteresis, hold functions, and two-sensor operations for through-beam sensors.
Details changing functions, set values, key lock, scaling, and initialization settings.
Describes common setting problems like inability to set scaling, monitor focus, or threshold values.
Provides detailed specifications for reflective, through-beam sensors, amplifier units, and calculating units.
