12
3.1 Installation Overview
A complete working system consists of the laser engraving machine, its integrated air assist and water
chiller, its vent and exhaust fan, its control computer, all applicable connection cables, and the laser key.
The cabinet can receive designs and commands from the control computer directly from its USB cable or
remotely from its wireless network or ethernet cable. The designs can be applied to flat surfaces resting
on the honeycomb workbed or to round surfaces supported on the provided rotary device. Users can
configure other additional accessories (such as a fume extractor) to suit their needs.
Use only the hardware, wiring, and power sources that came with or are compatible with
this device. Installing equipment that your device is not designed to work with can lead
to poor performance, shortened service time, increased maintenance costs, property
damage, and personal injury.
Please note the specific requirements of your system's installation. Every customer must understand these
notes before installation to execute a proper setup and achieve safe laser performance. If you have any
installation questions or problems, contact our technicians and customer support team.
Any auxiliary equipment must be adjusted to the base machine. Queries may be directed to the dealer or
manufacturer of such equipment.
3.2 Location Selection
Before you install your engraver, select an appropriate location for its use. Be sure that it meets all of the
requirements discussed in the Safety Information above.
The location should be stable, level, dry, and climate controlled to ensure an ambient temperature of 40–
104°F (5–40°C) and an ambient humidity of 20–85%. In particular, the temperature and humidity together
should not be close to the dew point. It is also advisable to use a windowless room or to use blinds and/
or curtains to avoid exposure to the potential additional heat of direct sunlight. The location should be
free of dust and other airborne pollutants and well ventilated enough to process any fumes produced by
the engraving process in accordance with all applicable laws and regulations. Depending on the materials
to be processed, this may require construction of a dedicated ventilation system. It should be away from
children; combustible, flammable, explosive, or corrosive materials; and sensitive EMI devices. The power
cord should be plugged into a compatible and stable power source via a grounded 3-prong outlet. No other
item should be drawing current from the same circuit. There should be firefighting equipment nearby and
the local fire department's phone number should be clearly displayed.
It is highly recommended to have extra storage area nearby to avoid placing any object on or directly
adjacent to the machine, which could become a fire or laser hazard.
INSTALLATION
To Next Page
Loading...
Need help?
General
