8
2.1 Disclaimer
Your Polar may differ somewhat from those shown in this manual due to options, updates, etc. Please
contact us if your engraving machine came with an outdated manual or if you have any other questions.
2.2 General Safety Instructions
• Your Polar 350 should come with warning labels in the following locations:
If any of these labels is missing, illegible, or becomes damaged, it must be replaced.
• Use this laser engraving device only in accordance with all applicable local and national laws and
regulations.
In the United States, the Polar’s wireless network is a certified transmitter module that emits radio
signals in compliance with 47 CFR 15 for commercial locations but may require operators to provide
additional equipment in residential areas to avoid interfering with emergency and FCC licensed
broadcasts. Similarly, the Safe Use of Lasers (Z136) standards published by the American National
Standards Institute do not have the force of law, but adherence to its provisions may be required by
some companies or local authorities to minimize risk and liability. In particular, it may be necessary
in commercial settings to formally designate a laser safety officer, to post warning signs in areas with
active lasers, and to document that all operators of laser equipment have been properly trained.
• Use this device only in accordance with this instruction manual and the manual for the engraving
software included with it. Only allow this device to be installed, operated, maintained, repaired, etc.
by others who have also read and understood both manuals. Ensure that this manual and the software
manual are both included with this device if it is ever given or sold to a third party.
• DO NOT leave this device unattended during operation. Observe the device throughout
operation and, if anything seems to be operating strangely, immediately cut off ALL
power to the machine and contact either our customer service or your dedicated
repair service. Similarly, ensure the device is FULLY turned off after each use.
SAFETY INFORMATION
To Next Page
Loading...
Need help?
General
