7
Rotary Axes
A. Rotary Aviation Plug—This plug should be covered during normal engraving. When you will use the
rotary axes, the 4-pin connection will power and direct the rotary motor.
B. Rotary Switches (covered)—These switches redirect power and control from the Y-axis motors to the
rotary axis connection and back again.
C. Tray Interlock—This switch must be held closed by the nearby bracket during rotary engraving. Remember
to reenable the switch by removing the bracket after your work.
D. Alignment Arrows—These arrows indicate the correct position of the laser and the X-axis rail for use
with Rotary Axis 1 (on the right) or Rotary Axis 2 (on the left).
E. Rotary Axis 1—This four-wheel rotary axis is installed into the bottom left corner of the open bay as
shown. The arrow at the end of the laser tube casing should be aligned with the arrow marked 1 on the
right side.
F. Rotary Axis 2—This four-wheel rotary axis is also installed into the bottom left corner of the open bay as
shown but the arrow at the end of the laser tube casing should be aligned with the arrow marked 2 on
the left side.
To Next Page
Loading...
Need help?
General
