26 | Chapter 2: Network Connections and Wireless Security
N300 Micro USB WiFi Adapter N300MA
c. In the Profile field, type the name of the profile.
d. Click Apply.
3. Save your settings in a profile.
a. Click Save Profile, and all the configuration settings are saved in this profile.
b. Click Apply, then click Close to exit the Smart Wizard, or click Cancel to return to
the previous settings.
4. Configure the computer network settings.
a. Configure each computer with either a static IP address or with the IPX protocol.
b. Restart the computers.
5. Verify wireless connectivity between your peer devices with the ping program:
a. On the Windows taskbar, select Start > Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type:
ping -t 192.168.0.1
and then click OK.
c. A continuous ping will be sent to the device with the 192.168.0.1 static IP address.
The ping response should change to Reply.
At this point the connection is established.
Note: If you cannot connect, see Removing the Software on page 15. For
problems accessing network resources, the Windows client and rile
and print sharing software might not be installed or configured
correctly on your computers. See the link to Internet Networking and
TCP/IP Addressing: in Appendix B.
To Next Page
Loading...
Need help?
General
