34 | Chapter 4: Troubleshooting
N300 Micro USB WiFi Adapter N300MA
The Smart Wizard keeps asking me to save settings.
If you change the settings, the Smart Wizard offers you the chance to save the changes. To
avoid this prompt, click Apply before you close the Smart Wizard.
Two N300MA icons are in the Windows system tray.
You have an older software version installed on your system and it needs to be removed. See
Removing the Software on page 15.
How can I view the IP address for the micro USB adapter?
Click the icon to open the Smart Wizard. Then click the About tab to view the IP address.
No IP address is assigned to the micro USB adapter.
This can occur if you upgraded your micro USB adapter software and did not reboot your
computer.
• Either restart your computer, or connect to a different access point.
• It does not usually help to shut down the Smart Wizard or disable or enable the micro
USB adapter.
Ad Hoc Mode Is Not Working Correctly
You must click the Initiate Ad Hoc button before you click Apply.
Note: Be sure that all computers in your Ad Hoc network are configured
with static IP addresses in the same subnet.
To start an Ad Hoc network:
1. Fill in the Network Name (SSID) field.
2. Select the Computer-to-Computer (Ad Hoc) network type.
3. Click Initiate Ad Hoc.
4. Accept the default settings, or make your changes and click OK.
Click Apply.
Windows XP Occasional Connection Problems
Windows XP users who apply Windows XP Hotfix (SP2) Q815485 from the Windows XP
Update Service might not be able to connect to the Internet, might have dropped wireless
To Next Page
Loading...
Need help?
General
