N300 WiFi Router (N300R) User Manual
1-12 Configuring Basic Connectivity
v1.0, May 2012
3. Select the region in which the wireless interface will operate.
4. Set the channel. The default channel is Auto.
This field determines which operating frequency is used. It should not be necessary to change
the wireless channel unless you notice interference problems with another nearby wireless
router or access point. Select a channel that is not being used by any other wireless networks
within several hundred feet of your router.
5. Make sure that the mode is set to Up to 145Mbps.
6. For Security Options, select None.
7. Click Apply to save your changes.
Note: In North America, the region cannot be changed, and is set by default to US.
Note: If you are configuring the router from a wireless computer and you change the
router’s SSID, channel, or security settings, you will lose your wireless
connection when you click Apply. You must then change the wireless settings
of your computer to match the router’s new settings.
To Next Page
Loading...