Onean Manta - P Ower of the Jet Unit

MANTA USER’S MANUAL
14
04
Use and ConfigUration of the eqUipment
2. On this position, press on the drop
until the rst LED of the board display
on the controller beings to blink. At
this moment, the LED bar will begin to
progressively light up.
3. Once the first LED begins to blink,
you must press on the drop again to
access the submenu. In this submenu,
the controller will begin to search for a board for a few seconds
and the sync LED will begin to blink.
4. As the sync LED is blinking the battery must be inserted to
complete the synchronization (see 4.1.2.).
5. Once the board is synched, both LEDs will blink at a higher pace
indicating that the process has been successfully completed.
6. Once the synchronization is finished the controller will
turn o and the conguration will be stored.
7. If you do not want to change any of these parameters you don’t need
to do this process again, it will remain in the internal memory of the
controller.
8. Always use the controller inside the controller wristband.
9. Always secure the wristband before use.
10. In order to activate the jet, press on the drop with the index nger and
thumb.
11. The power will vary depending on the clicks made on the drop.
4.2.2. PoWer oF the Jet unit
In order to activate the Jet Unit, press on the Drop. The Manta has 3 levels: o
(0%), 50% power and 100% power.
50% PoWer
To activate the Jet Unit press one time on the Drop.
The Jet Unit will be activated at 50% of its total power.
100% PoWer
To proceed with 100% of the power press on the drop once again.
StoP
To stop the Jet Unit press on the drop a third time. If you are on 50% (1 click)
you must press two times to stop the Jet Unit.
STOP
100%
50%
SYNC BATTERY
LED Blinking
2
LEDs Power [W] Display
1 click 400w
2 clicks 750w
3 clicks 0w STOP
% power
Clicks on the Drop
3 clicks
0
20
40
60
80
100
1 click 2 clicks
Staggered