Onean Manta - 4.4. SECURITY MECHANISMS

MANTA USER’S MANUAL
16
04
Use and ConfigUration of the eqUipment
4.4. Security MechaniSMS
The board has various security mechanisms that stop it automatically in case
of:
• Engine overheat.
• Battery overheat.
• Loss of communication between the controller and board.
• Tightening of the jet when starting or blockage of the turbine due to an
external object.
• Magnetic key disconnection. In case of fall, it will automatically disconnect.
• In case of fall, or if the controller is submerged, the jet will stop as a
security measure.
If any of the previous cases happens during use, the jet will automatically
stop. This security block will remain until the above causes are solved.
In order to reactivate the board, the security magnet must be disconnected
and reconnected.
5.1 terMS oF uSe
• The Manta board is suitable for fresh and salt water use. Ideal conditions
are with no wind and at water.
• Be aware of local regulations before using and the areas where this
kind of equipment is eligible for use.
• Taking into account that the jet sucks water through the intake it is
important to look for waters free of oating elements at which to practice
this sport. Mentioned floating elements could cause damage to the
rotating elements inside the waterjet.
• The Manta Board has not been designed to be used at wave breaking
areas. Please look for an area of calm waters at which to entry the water.
• Taking into account the high speeds and manoeuvrability of the board, it
important to use the Manta at large open spaces free of obstacles.
• Be aware of the tides. With the sea level changes, new obstacles may
arise depending on the tide.
• Avoid using this product in the vicinity of other people, vessels or objects
that may compromise the user’s or board’s security.
• Avoid crowded beaches and always respect the navigation channels.
• In case of entering the water through the beach, make use of the marked
areas that allow the entry and exit of watercrafts.
• It is advisable not to overturn/ip the board in the water.
• Do not grab or lift the board by the discharge connectors.
• Do not remove the goretex vent in the back of the board.