MANTA USER’S MANUAL
10
04
Use and ConfigUration of the eqUipment
4.1. battery
4.1.1. battery tranSPort and Storage
• In order to travel with the board, the battery must be below 20% of charge.
This means that the LED bar must be only showing one LED.
Placing the drop near the battery display you will be able to check the
battery level.
• Do not transport the battery inside the board unless you intend to
use it immediately.
• Between uses you should store the battery between 0ºC y 40ºC (32°F a
104°F) always less than 3 months, in a ventilated area and with a humidity
between 0% - 80%. Do not store the battery near metallic objects.
4.1.2. connecting/diSconnecting the battery
Always charge the battery and remote to the fullest before operating the
equipment.
Connection and disconnection of the battery:
1. Check the watertight seal and the battery housing to make sure they are
clean and free of sand. Make sure there aren´t any signs of damage before
use. Make sure there isn´t any water inside the battery compartment.
2. Turn the vent one full round counter-clock wise. Place the battery on the
pad, near the battery compartment where the battery must be placed.
Once the battery is placed on the pad, grab it by the upper handle
and place in the battery compartment.
The blue LED on the front of the board will
light up indicating the connection.
Drop
Sensor
Charging
indicator
Battery connectors
SYNC BATTERY
Visualization Charge%
20%
40%
60%
80%
100%
To Next Page
Loading...
