Onicon F-5500 - Page 40

Measurement Mode Display Screens
In the measurement mode, there are four different display screens (display 1, 2, 3
and a prompt screen to enter the programming mode). Two display screens are
user programmable (refer to Display Setup p. 46). Scrolling through the display is
accomplished by pressing the F1 or F2 key to view the next or previous screen.
Pressing the F1 and F2 keys at the same time enters the Engineering Menu screens
(display 10 through 26). Key F4 is used to exit to Display screen #1.
Pressing the F3 and F4 keys at the same time brings up the Reset Total screen (see p.
56) prompt.
Fig. 4.2: F-5500 Measurement Mode Display Screen Navigation
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-5500 Thermal Mass Flow Meter Manual 06/17 - 2030 / 107023 Page 40
Model F-5500
OPERATION
Display Screens
F1 key: Moves up one screen
F2 key: Moves down one screen
(User programmable screen)
(User programmable screen)
Enter “totalizer reset screen”
when F3 & F4 are pressed at
the same time
(Fixed screen)
Enter programming screen
Requires password.
Default is 1234.
Display #1
Display #2
Display #3
Display #4
(Fixed screen)
F1
F1
F1
F1 F2
F2 F4
F2
F2 F3 F4
1456.5 SCFH
Tot=123456 SCF
Elp = 14.6 HR
88.5˚ F
Alarm = None
Gas = Air
SET PARAMETER?
No Yes
Operation: Display Screens
Reset Total
Screen
Engineering
Menu Screens