i
i
i
Pressing SIM (F1) will show:
F1 F2 F3 F4
Press YES (F1) to continue.
F1 F2 F3 F4
Enter the value and then press OK (F4).
NOTE: Enter zero to disable this feature.
F1 F2 F3 F4
Press YES (F1) to continue.
F1 F2 F3 F4
Enter the value and then press OK (F4).
NOTE: Enter zero to disable this feature.
F1 F2 F3 F4
Press YES (F1) to start the simulation mode, otherwise press NO (F4). Upon pressing
either key, the program will return to the FLOW MENU 1 screen.
NOTE: Simulation Mode will be cleared if the power is cycled.
Model F-5500
OPERATION
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-5500 Thermal Mass Flow Meter Manual 06/17 - 2030 / 107023 Page 57
ENABLE SIM?
YES NO
TmpSim = 0 ° F
CHG OK
Simulate Temp?
YES NO
FloSim = 0 SCFH
CHG OK
Simulate Flow?
YES NO
Operation: Programming
To Next Page
Loading...