Onkyo A-8500 Instruction Manual

Observe the following precautions to obtain troublefree
performance
for
many
years.
Precautions
Sa
1. Avoid places subject to direct sunlight or extremely high or low
temperatures. 1. Warranty Card
2.
Avoid
damp
or
dusty
places
and
places
directly
affected
by
The
serial
number
is
written
on
the
rear
panel
of
this
unit.
Copy
vibrations
from
the
speakers.
In
particular,
avoid
placing
the
the
serial
number
and
model
number
onto
your
warranty
card
unit on or above one of the speakers. and keep it in a safe place.
2. Recording Copyright
3. Avoid unstable locations and high places from which the unit Recording of copyrighted material for other than personal use
could fall. had eee :
ae ; ; : ; is illegal without permission of the copyright holder.
4. Ventilation — The unit should be situated so that its location 3. AC Fuse
or position does not interfere with proper ventilation. For ex- The fuse is located inside the chassis and is not user serviceable.
ample, the unit should not be placed on a bed, sofa, rug of
similar surface that could block the ventilation openings or If power does not come on, contact your Onkyo dealer.
placed in a built-in installation, such as a bookcase or cabinet, 4. Care : : :
that
could
impede
the
flow
of
air
through
the
ventilation
From
time
to
time
you
should
wipe
off
the
front
and
rear
panels
openings.
and
the
cabinet
with
a
soft
cloth.
For
heavier
dirt,
dampen
a
soft
cloth in a weak solution of mild detergent and water, wring it
out dry, and wipe off the dirt. Following this, dry immediately
with a clean cloth. Do not use rough material, thinners, alcohol
or other chemical solvents or cloths since these could damage
the finish or remove the panel lettering.
5. Heat — The unit should be situated away from heat sources
such as radiators, heat registers, or other appliances (including
amplifiers) that produce heat.
6. Cleaning of the internal parts should be performed only by
qualified service personnel.
5. Power
7. Spillage — Care should be taken so that objects do not fall and WARNING
liquids are not spilled into the enclosure through the openings. BEFORE TURNING ON POWER FOR THE FIRST TIME, READ
8. Damage Requiring Service — The unit should be serviced by THE FOLLOWING SECTION CAREFULLY.
qualified service personnel when: @ Some models are designed for use only with the power supply
A. The power supply cord or the plug has been damaged; or voltage of the region where they are sold.
B. Objects have fallen or liquid has been spilled into the unit; European models
or
C. The unit has been exposed to rain; or texcont mes . Neze0y ACHE
D. The unit does not appear to operate normally or exhibits a Canadian models: AC120V, 60Hz
marked change in performance; or U.K. & Australian models: AC 240V, 50Hz
E. The unit has been dropped or the enclosure damaged. Worldwide models: 120 and 220V switchable,
9. Servicing — The user should not attempt to service the unit 50/60Hz
beyond that described in the operating instructions. All other
servicing should be referred to qualified service personnel.
® Voltage Selector (Rear Panel)
Worldwide models are equipped with a voltage selector to
conform with focal power supplies. Be sure to set this switch
@
This
apparatus
complies
with
requirements
of
EEC
directive
to
match
the
voltage
of
the
power
supply
in
your
area
before
82/499/EEC. : turning the power switch on. Voltage is changed by sliding the
groove in the switch with a screwdriver to the right or left.
Confirm that the switch has been moved all the way to the right
or left before turning the power switch on. Models without a
voltage selector can only be used in areas where the power
supply is the same as that of the unit.
220V™ 120V™ 220V™ 120V
at AC120V at AC220V

Onkyo A-8500 Specifications

General

Brand	Onkyo
Model	A-8500
Category	Amplifier
Language	English