Onkyo A-9010 User Manual

En-11
Operations
Í ON/STANDBY button
Remote control sensor
Volume control
Input source LEDs
MUTING LED
ASB (Auto Standby) LED
INPUT selector
BASS control
TREBLE control
BALANCE control
DIRECT LED
DIRECT button
LOUDNESS LED
LOUDNESS button
LINE 5 jack: Connects to reproducing equipment such
as portable audio player via stereo mini-plug
(ø 3.5 mm).
PHONES jack
Turning on the unit
1. Press the Í ON/STANDBY button.
The input source LED blinks, then lights up after a
short time.
To return to standby mode: This unit will go into
standby mode by pressing the Í ON/STANDBY button
again, then the input source LED will go off.
0 The power of Onkyo equipment connected via RI will
be automatically turned off when the power is turned to
standby.
Adjusting the volume
1. Adjust the volume by slowly turning the volume
control.
Selecting the input source
1. Switch the input source by turning the INPUT
selector.
Input from following can be selected.
(North American and Continental European models)
D 1, D 2, LINE 1, LINE 2, LINE 3, LINE 4, LINE 5,
PHONO
(UK models)
LINE 1, LINE 2, LINE 3, LINE 4, LINE 5, PHONO
The input source LED corresponding to the
selected input lights up.
0 If there is no input signal when D 1 or D 2 is
selected, the LED for that source will blink.
(UK models)
The Auto Standby can be set on this unit. For detail,
refer to “Setting the Auto Standby function” (> 12).
A-9010_eng.book 11 ページ ２０１４年１２月２５日 木曜日 午前１０時４８分

Onkyo A-9010 Specifications

General

Damping factor	95
Amplifier class	-
Frequency range	10 - 100000 Hz
Input sensitivity	150 mV
Audio output channels	2.0 channels
Peak power per channel	44 W
Signal-to-Noise Ratio (SNR)	92 dB
Total Harmonic Distortion (THD)	0.08 %
Purpose	Home
Product color	Black
Connectivity technology	Wired
AC input voltage	220-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.4 W
Power consumption (typical)	25 W
Package weight	8200 g
Manual	Yes

Weight and Dimensions

Depth	3 mm
Width	435 mm
Height	129.5 mm
Weight	6500 g