54
Naming an MD and its Tracks, and Preset Channels—Continued
Inputting characters from the remote controller
1
Press NAME.
2
Press DISPLAY repeatedly until the character type you wish to enter appears
in the display.
Each press of the DISPLAY button switches the type of characters. If you press SCROLL,
the type of characters switches in reverse order.
• Inputting alphabetical characters:
Each press of a number button cycles through a few characters of the alphabets. For
example, repeatedly pressing the button displays A→B→C→A in this order. Display
the desired character, then press ENTER.
• Inputting an Easy Name: (Only for MD)
Each press of the number buttons switches between the Easy Names that start with the
same characters as the buttons. For example, repeatedly pressing the button dis-
plays the Easy Names that start with A, B, or C, such as BALLAD, BLUES, and CLAS-
SIC. Display the desired Easy Name, then press ENTER.
• Inputting numbers and symbols:
Pressing a number button displays the corresponding number. Each press of the but-
ton or the 10/0 ( ) button switches between the symbols labeled on the corresponding
button. You can input “ → . → / → * → - →, → ! → ? → ’→ ( → ) ” using the button, and
(space) using the button. Display the desired number or symbol, then press
ENTER.
You can also use the remote controller’s or button, then press ENTER to select
and input a character.
Note
You cannot input all symbols from the remote controller’s number buttons. To input symbols, use the
remote controller’s or button to select the desired symbols.
3
Press the NAME button to complete the naming process.
SOURCE C D TIMER M D M D C D
To Next Page
Loading...
