Firmware
5 4 3
2
1
6
D
C
A
B
D
C
A
B
5 4 3
2
1
6
How to Update (service mode) 2/2
5. Wait until update is completed. When the update ends, “Completed!” is displayed. When
“ Completed!” message appeared, you can power off by pressing “ ON/STANDBY” button.
(If you leave it, it automatically turns standby mode. )
6. Press [ON/STANDBY] button, and the unit turns on.
7. Check the new FW version number.
<Note>
If the procedure might not be successful, please select “MMC -> ALL”.
TX-SR343/444
HTR-494
To Next Page
Loading...
