55
En
Controlling Zone 2 with the Remote
Controller
Note
• To control Zone 2, you must press the remote controller’s
ZONE2 first.
Adjusting the Volume for Zone 2
■ Operating with the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the
volume.
Muting Zone 2
■ Operating with the remote controller
Tip
• To unmute, press ZONE2 followed by MUTING again.
Note
• Only analog input sources are output by the ZONE 2 LINE
OUT and FRONT HIGH OR ZONE 2 SPEAKERS L/R ter-
minals. Digital input sources are not output. If no sound is heard
when an input source is selected, check if it’s connected to an
analog input.
• While Powered Zone 2 is being used, listening modes that
require surround back speakers and front high speakers (6.1/7.1),
such as Dolby Digital EX, DTS-ES, THX Select2 Cinema, and
Dolby Pro Logic IIz Height are unavailable.
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same FM/AM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
• Zone 2 can also be unmuted by adjusting the volume.
1
Press ZONE2 and then press ON/STANDBY.
Zone 2 turns on, the ZONE 2 indicator lights.
2
To select an input source for Zone 2, press
ZONE2, followed by an input selector button.
To select AM or FM, press the TUNER input selec-
tor repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press ZONE2 followed by ON/
STANDBY.
ON/STANDBY
MUTING
VOLq/w
ZONE2
Input selector buttons
1
Press ZONE2.
2
Use VOL q/w to adjust the volume.
1
Press ZONE 2 (the ZONE 2 indicator and Zone 2
selector on the display flashes).
2
Use –/+ within 8 seconds to adjust the volume.
Press ZONE2 followed by MUTING.
To Next Page
Loading...
