En-18
Turning On the Receiver
Press the [ON/STANDBY] button.
Alternatively, press the remote controller’s []
button.
The receiver comes on, and the display lights up.
To turn the receiver off, press the [ON/STANDBY]
button, or press the remote controller’s [] button. The
receiver will enter Standby mode. To prevent any loud
surprises when you next turn on the receiver, always turn
down the volume before you turn it off.
Note:
If you can’t use the remote controller to turn the receiver
on/off, make sure that REMOTE MODE is set
correctly.( page 9)
For the [TV/TAPE], [VCR/DVR] and [GAME] buttons,
the input display name can be changed as shown below.
When the input display name has been changed for one
of the buttons below, the display name for the other
button cannot be changed.
• [TV/TAPE] button :
TV/TAPE
DOCK
• [VCR/DVR] button : VCR/DVR
DOCK
• [GAME] button : GAME
DOCK
1
Press the remote controller’s appropriate
INPUT SELECTOR button.
The selected input name appears in the display.
2
Press and hold down the INPUT SELECTOR
button selected in the Step 1 above for
approximately 3 seconds to change the
display name.
To Next Page
Loading...
