Onkyo TX-8211 - Adjustment Procedures Overview; Adjustment Preparation and Inputs; Adjustment Outputs; Standard Knob Positions

Connecting antennas
Insert into the slot.
Outdoor
FM/TV
antenna
300 ohm
ribbon wire
Directional linkage
type splitter
To TX-8211
To TV (or VCR)
1. Open the lever.
2. Twist wire ends very Ught, and insert
the wire.
3. Close the lever.
ee
ik
ae
ate
Ss
agers
a
fens
AM
loop’antenna
:
q
oseses aah
Assemble the loop antenna as shown in the
illustration. (Refer to the next page for
details on connecting the AM _ loop
antenna.)
5S eed ees : 5
t 75/300 ohim'adaptor=*- fs":
' (worldwide and some other 4
‘ models) <0 a
Connecting the 300 ohm ribbon wire to
the 75/300 ohm adaptor
Loosen the screws and wrap the wires
around them. Then, tighten the screws with
a screwdriver.
Connecting the coaxial cable to the 75/
300 ohm adaptor
1. With a small screwdriver, pull the stop-
pers outwards and remove the cover.
. Remove the transformer wire A from
slit B and insert it into slit C.
3. Prepare the coaxial cable as shown in
the illustration, Connect the coaxial
cable to the 75/300 ohm antenna adap-
tor.
@ Insert the end of the cable.
@ Use pliers to pinch it and keep it in
place.
to
4. Re-install the cover.
pa ad Bea ee eat
i, Directional linkage . +
Do not use the same antenna for both FM
and TV (or VCR) reception since the FM
and TV (or VCR) signals can interfere with
vach other, If you must use a common FM/
TV (or VCR) antenna, use a directional
linkage type splitter.